Jasco 45131 Manual de Instruções

45131ChoiceALERTChoiceALERT™Control all Sensors & accessories from one location™Wireless Alarm SystemWindow/Door SensorUser’s Manual

1011Note: The Zone/Sensor cannot be erased if:- The Zone has been triggered for an Alert or alarm. The Sensor/Zone must be reset.- There is loss o

1011Model # Description Battery Type Battery Life*45129 Control Center (4) “AAA” 24 months45131 Window/Door (1) “2032” 24 months

1213Window/Door Sensor F.A.Q.’SQ. I bought a new Sensor and the Control Center will not recognize it. Why?A. First, make sure the yellow isolation t

1213Q. Why does one of my Zones continually flash?A. This can be caused by 1 of 2 conditions. First condition, if it is a rapid flash it means a Sens

1415FCC WarningAny unauthorized changes or modifications to the equipment would void the user’s warranty and may conflict with both state and federal la

1415WARNINGLimitations of Alarm ProductsThis product should be tested periodically to make sure it is working properly. The product, if used properly,

is a trademark of the General Electric Company and is used under license to Jasco Products Company LLC, 10 E. Memorial Road, Oklahoma City, O

23Important Safeguards 4Introduction 5Installation 6Assigning a Sensor to a Zone 8Erasing a Sensor from a Zone 9Testing a Senso

23Before connecting or operating the Window/Door Sensor, please read these instructions carefully and save this manual for future reference.Congratula

45Important safeguardsPreCautions1. Do not attempt to disassemble the Window/Door Sensor, unless described in the user’s manual. There are no user ser

45IntroductionThe Window/Door Sensor is designed to be used indoors or out. When mounted properly it can monitor doors, windows, gates, cabinets, etc.

67Preparing the Sensor for InstallationThe Window/Door Sensor consists of two parts – The Sensor (Transmitter) and the Magnetic Contact. Before instal

67Depending on what side of the door the Sensors mounted, the Sensor cover can be rotated, but the red marks must always be aligned in order for the S

89between the Magnetic Contact and the Sensor must be no greater than ½”. Once the plate is mounted, use the doubled sided tape to attach Sensor to th

89 Step 3 – Release all buttons.Note: Zone 4 is for dedicated alerts only. Sensors in this Zone will not trigger an alarm or chime. Step 4 – Activat